Threaded Mode | Linear Mode

Chasfield · (This post was last modified: 09-11-2016 12:24 PM by Chasfield.)

I have tidied up the battery modification by making a flush fitting cover out of some scrap ABS sheet, which will be retained by a square of adhesive tape. This will suffice, as the SR-44s are at least as secure with no cover than the original N cells were when restrained by the stock item. I also cemented a blanking plate over the soldering access aperture. This was fashioned from a piece of a defunct Rockwell 18R rear case. The textured brown plastic is similar to the stuff HP used on the 19BII.

Some slightly deeper than stock adhesive rubber feet will finish the job.