Synthetic

[hth]

(11-21-2016 07:00 PM)Leviset Wrote:  Ok I've sussed out the Synthetic Programming using MK and BG from the PPC ROM on the Clonix-D.
Still need some help with the Machine Code question please!
Dennis

The Clonix-D will be able to run your MCODE programs, provided that you create a module image for it.

There are basically two ways to create such images. Either you do it on a host computer and use tools, such as an assembler to put a module image together. The second way is to do it on the HP-41 itself, but in that case you need a module that provides RAM (pages).

Clonix modules at some point allowed for a small amount of RAM as well, but I am not sure about the status of this. The manual mentions it, but it seems to be gone in the source code.

In case it is possible to get that RAM working, you can do MCODE on the HP-41. Modules such as Zenrom, Davids Assembler might be useful in that case (I have never tried them). There is also a debugger ROM that was made available recently.

What host computer (operating system) do you use? Are you familiar with developing using tools on a host computer?

Håkan