Threaded Mode | Linear Mode

Harald · (This post was last modified: 12-14-2016 03:56 PM by Harald.)

Hi Tony,

I finaly found the time to try your emulator. Unfortunately I did not get very far. It starts and I can type numbers. But as soon as I press enter, I get an error message saying the number is not a valid floating point number.

I am running Windows 8, might that be the problem?

Edit: I do not get the error message if I turn off the printer. However, once I have entered a number and turn the printer back on, I can print it. Just can't enter numbers or calculate while the printer is on.