HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Leaving original user input in verbatim on CL after execution... any ideas?

Post Reply 
Leaving original user input in verbatim on CL after execution... any ideas?
01-30-2017, 02:47 PM
Post: #4
Fortin Offline
Member
 		Posts: 59
Joined: Jul 2015
RE: Misbehaving ENG num format... any ideas?
(01-30-2017 06:59 AM)Tim Wessman Wrote:  I set to engineering 3, put in 1e-20 or similar examples, and then tapped them to copy back. They all came back in eng notation.

Did you try values that could also display as a decimal without a need for exponent notation? E-20 is a bit too small to cause the issue (too many 0s).
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Misbehaving ENG num format... any ideas? - Fortin - 01-30-2017 02:47 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication