Crash in calculator

[toml_12953]

(03-27-2017 05:24 AM)math7 Wrote:  I deleted all the applications and programs that were installed on the calculator and restored with the reset button and tried by creating a new program and the calculator was not crash. Then I thought I had solved the problem but no. I discovered that the calculator is reset when creating two programs. For example, I make a new program with the program editor and I put a name as Prog1 and left it without instructions and I give it ok and no problem, but when doing a second program either, I enter the name and I give ok and the Calculator is reset, it is very strange. In addition to this, in the Home mode there are some values ​​for real variables, and with no command I can delete those values, for example the variable X had a value of 2,785 .... and I write DelHVars (X) and I give enter and it puts 0 But if I type X on the command line and hit enter it comes out again with its value of 2,785; The only way is to enter with the keys Shift + Mem and from there reset one by one each variable which is very tedious, there should be a command to do it once and for all.

It definitely sounds like you have bad RAM. At least one location can't hold a value. If the calculator is in warranty, return it for repair or, most likely, replacement.

Tom L