Threaded Mode | Linear Mode

PANAMATIK · (This post was last modified: 04-28-2017 07:54 AM by PANAMATIK.)

(04-28-2017 01:21 AM)nsg Wrote: I tired to debug program on 33c (np25 actually) by stepping through.
When I sst over GSB instruction it goes into calculation mode and executes entire subroutine until rtn. Is there a trick way to stay in operation mode so I can step-by-step the contents of subroutine as well?

Press SST twice very fast if you encounter a GSB instruction.This will stop inside the subroutine. Two or three instructions are executed though. You could add a PAUSE instruction as first subroutine step and replace it by NOP after debugging.

Bernhard