HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / How to use "Engineer Notation" (SI Prefixes)?

Post Reply 
How to use "Engineer Notation" (SI Prefixes)?
05-16-2017, 02:20 AM
Post: #2
Joe Horn Offline
Senior Member
 		Posts: 2,018
Joined: Dec 2013
RE: How to use "Engineer Notation" (SI Prefixes)?
I think that Prime only "understands" SI prefixes when they are attached to valid units, which IMHO makes sense, because they are prefixes, not units.

[Image: prefixes.png]
<0|ΙΈ|0>
-Joe-
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: How to use "Engineer Notation" (SI Prefixes)? - Joe Horn - 05-16-2017 02:20 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication