HP Forums / HP Calculators (and very old HP Computers) / General Forum v / 9815/9825 Capstan

Post Reply 
9815/9825 Capstan
06-06-2017, 04:08 AM
Post: #3
Geoff Quickfall Offline
Senior Member
 		Posts: 859
Joined: Dec 2013
RE: 9815/9825 Capstan
Tygon turrned on a lathe to the correct outer and inner diameter. Kluging doesn't seem to work.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
9815/9825 Capstan - aj04062 - 06-05-2017, 11:37 PM
RE: 9815/9825 Capstan - Craig Bladow - 06-06-2017, 03:02 AM
RE: 9815/9825 Capstan - Geoff Quickfall - 06-06-2017 04:08 AM
RE: 9815/9825 Capstan - Craig Bladow - 06-07-2017, 06:54 PM
RE: 9815/9825 Capstan - cruff - 06-08-2017, 12:12 PM
RE: 9815/9825 Capstan - Craig Bladow - 06-16-2017, 01:13 PM
RE: 9815/9825 Capstan - Katie Wasserman - 06-19-2017, 01:34 PM
RE: 9815/9825 Capstan - Etienne Victoria - 06-19-2017, 02:49 PM
RE: 9815/9825 Capstan - Craig Bladow - 08-26-2017, 06:18 PM
RE: 9815/9825 Capstan - aj04062 - 08-27-2017, 12:37 AM
RE: 9815/9825 Capstan - Craig Bladow - 08-27-2017, 02:52 AM
RE: 9815/9825 Capstan - vassilisprevelakis - 09-07-2017, 01:32 PM
RE: 9815/9825 Capstan - Craig Bladow - 09-09-2017, 08:25 PM
RE: 9815/9825 Capstan - vassilisprevelakis - 09-12-2017, 07:10 PM
RE: 9815/9825 Capstan - vassilisprevelakis - 09-12-2017, 05:36 PM
RE: 9815/9825 Capstan - Craig Bladow - 09-13-2017, 12:09 AM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication