Who wants a new printing HP-42s?
|
06-14-2017, 09:31 PM
Post: #13
|
|||
|
|||
RE: Who wants a new printing HP-42s?
If a good way to produce 3D printed keys (mechanism, switches, etc) is figured out, we can use that for other calculator reproductions/resurrections, such as the 48G series.
Everything else inside the case can be almost the same except for the firmware. I expect in 10 more years, this can be done, but not sure about current status of 3D printers (especially the more affordable sub-$500 ones). I don't have a 3D printer but will get one sooner or later. Right now the most affordable one seems to be the Monoprice one at around $200 and supposedly it is "not bad". |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 3 Guest(s)