Creating overlays / custom key kaps for cherry switches

[Paul Dale]

(07-06-2017 01:15 PM)Harald Wrote:  I can't believe there is no setup charge with the double shot keys, but I can inquire if and when the project has progressed that far.

Me either. $50 to make a custom double shot mould and run off fifty is insanely cheap.

(07-06-2017 11:38 AM)Paul Dale Wrote:  Existing (i.e. cheaper) keys could also be used -- either bought singly or extracted from keyboards. E.g. https://mechanicalkeyboards.com/shop/ind...ail&p=2247 is the beginnings of a calculator. A few custom keys and it could be nice. Twenty three keys and a display is on the low end.

A mixture of existing keys and custom ones might be a good compromise.

Quote:I guess the keys only make sense if others are intereted in the project, too.

I'd be tempted


Pauli