Mistake Copying from History Screen

[Helge Gabert]

So, to recap, after entering int(x^i,x):

The <Show> soft key displays the result correctly.
The <Copy> soft key displays (and enters) the result incorrectly.

Also, after entering just x^(1+i):

a) Highlighting x^(1+i) on the left hand side of the history screen copies correctly into the command line.
b) Highlighting x^(1+i) on the right side of the history screen copies as x^1+i, or x+i. But again,<Show> displays x^(1+i).

I can't believe this behavior has always existed - - it must have been correct in previous firmware versions (or else, I produced a bunch of wrong results, and nobody noticed (!)).