HP 35S Error Handling
|
11-03-2017, 07:38 AM
(This post was last modified: 11-03-2017 07:49 AM by Dieter.)
Post: #4
|
|||
|
|||
RE: HP 35S Error Handling
(11-02-2017 11:22 PM)JeremyBeck Wrote: Thanks for the reply Dieter. I did try as you suggested and allocated the first 100 registers by storing 0 in an (i) of 100. Of course you have to store a non-zero (!) value in R100. (11-02-2017 11:22 PM)JeremyBeck Wrote: this stopped the error when recalling (i)50 for example. a zero is returned instead of INVALID(I). Yes. Now R000....R100 are allocated and useable. Since nothing has been stored in R50 before it is recalled as zero. (11-02-2017 11:22 PM)JeremyBeck Wrote: One other question I had is that I am working on several programs (one of which is a program to store a point with coordinates in storage registers 1 through 100 as a vector in the format of [northing, easting, elevation]). the program works as intended but I would like to share my programs for other users who might find them helpful. Would this forum be the place for that? If you want to publish programs for the 35s you should do so in the General Software Library section of this forum. The subject line should start with "(35s)". If you can't find your program after posting: that subforum is sorted in alphabetical order, you may have to switch to "last post on top" manually. ;-) Dieter |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP 35S Error Handling - JeremyBeck - 10-28-2017, 04:04 PM
RE: HP 35S Error Handling - Dieter - 10-31-2017, 05:57 PM
RE: HP 35S Error Handling - JeremyBeck - 11-02-2017, 11:22 PM
RE: HP 35S Error Handling - Dieter - 11-03-2017 07:38 AM
|
User(s) browsing this thread: 2 Guest(s)