41CL Self-Update

[Neve]

(11-19-2017 06:31 AM)Sylvain Cote Wrote:  

(11-19-2017 05:37 AM)Neve Wrote:  Everything is fine until I execute XEQ “YGETLB”. At this point The display shows almost immediately “TIMEOUT”.

Check that your loopback wire is fully connected.
I got the same timeout message, then I realized that the loopback wire was not fully connected.
I plugged the wire correctly, then redid the complete procedure and it worked.
Sylvain

I’ll try that again, thank you Sylvain.
Je commence à désespérer...