HP Forums / HP Calculators (and very old HP Computers) / General Forum v / pyILPER 1.6.0 and LIFUTILS 1.7.7 final release

Post Reply 
pyILPER 1.6.0 and LIFUTILS 1.7.7 final release
11-29-2017, 07:22 AM
Post: #4
jsi Offline
Member
 		Posts: 115
Joined: Jun 2015
RE: pyILPER 1.6.0 and LIFUTILS 1.7.7 final release
(11-28-2017 11:30 PM)rprosperi Wrote:  1. Uninstall old LIFUTILS
2. Install new LIFUTILS (using appropriate x32 or x64 setup program)
3. Use the "conda update --all" method (I assume this is the same even if I have miniConda installed) to update pyILPER client to 1.6.0

That's absolutely correct. This procedure applies for the other platforms as well. Anaconda or miniConda make no difference in this case.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: pyILPER 1.6.0 and LIFUTILS 1.7.7 final release - jsi - 11-29-2017 07:22 AM



User(s) browsing this thread: 9 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication