HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Arduino Board as HP-IL device?

Post Reply 
Arduino Board as HP-IL device?
04-08-2014, 09:34 PM
Post: #8
Jurgen Keller Offline
Senior Member
 		Posts: 343
Joined: Dec 2013
RE: Arduino Board as HP-IL device?
Quote:Well, installing the PIL-Box firmware on the PIL-IO just means plug the existing PIL-Box uC on the PIL-IO board. Or, if you prefer, remove (or disconnect ) the USB module from the PIL-Box and add a connector for the serial lines and the supply. So almost no effort:-)
Ha, that's easy indeed. Wonderful!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Arduino Board as HP-IL device? - BobVA - 04-09-2014, 08:55 PM
RE: Arduino Board as HP-IL device? - Jurgen Keller - 04-08-2014 09:34 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication