HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / Exactly how do you update the DM42 Firmware?

Post Reply 
Exactly how do you update the DM42 Firmware?
12-28-2017, 07:30 PM
Post: #29
zeno333 Offline
Member
 		Posts: 197
Joined: Mar 2015
RE: Exactly how do you update the DM42 Firmware?
My mistake,

STM bootloader driver is required but is loaded automatically using the following link

https://www.swissmicros.com/dm42/doc/libusb_install/

The wizard takes care of it. Once the library drivers are installed then follow my instructions on the first post.

Geoff
[/quote]
Confused...how does it take care of getting the driver?...So the stm32 zip file is not needed at all then? Where does it get it if I I not install it?....
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Exactly how do you update the DM42 Firmware? - zeno333 - 12-28-2017 07:30 PM



User(s) browsing this thread: 7 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication