HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / newbie question: how to take element from an array on command line

Post Reply 
newbie question: how to take element from an array on command line
12-30-2017, 08:20 PM
Post: #7
Rudi Offline
Junior Member
 		Posts: 15
Joined: May 2015
RE: newbie question: how to take element from an array on command line
A possible solution:

a:=iquorem(63,23)
a(1)
a(2)

   

Best Regards
Rudi
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: newbie question: how to take element from an array on command line - Rudi - 12-30-2017 08:20 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication