WP 34S - How do I use aGTO with stack registers?

[Dieter]

(01-05-2018 09:15 AM)Martin Hepperle Wrote:  Only the last case (my second '3)' which should have been a '4)') did not work for me:

Quote:3) Direct addressing via a stack register
If I have 101 in RX and "aGTO .X", I would expect the same outcome, but I receive "No such Label".

I don't have my WP34s here at hand to try now.

Well, over here it works. At least on the emulator. ;-)
I placed a LBL"e" somewhere in the code, positioned the program somewhere else, and then 101 aGTO X jumped right to that label again.

Please also note there is a difference between LBL A and LBL"A". And there is no need to press "." for the stack registers. Simply press aGTO Z or aGTO T. OK, "X" is on the key with the decimal point. The official stack prefix is ENTER which displays an "s".

Dieter