Finally acquired a Woodstock

[rprosperi]

(01-09-2018 03:14 AM)mfleming Wrote:  I struggled quite a bit to set up a Shapeways shop to make the design available for order (no markup) or download. Quite a pain! Try this link and PM me if there are problems. You'll like the case - no tape to hold the halves together.

https://www.shapeways.com/product/6NQAST...d=64514022

Mark,

I believe I somehow missed this case when you introduced it, and just saw this now. A 1-piece case is a very nice answer for this nagging problem.

Is this case designed for 'normal' cells with the button top on the positive end, or for 'flat top' cells like the originals that came with a Woodstock?

Also, do you have a recommended source for the required spring for the 'far' end of the holder? I've seen similar springs for '41 battery holders, but not sure if the case geometry is the same.

Nice!