HP Forums / HP Calculators (and very old HP Computers) / General Forum v / pyILPER 1.6.0 and LIFUTILS 1.7.7 final release

Post Reply 
pyILPER 1.6.0 and LIFUTILS 1.7.7 final release
02-05-2018, 09:40 PM
Post: #26
salvomic Offline
Senior Member
 		Posts: 1,396
Joined: Jan 2015
RE: pyILPER 1.6.0 and LIFUTILS 1.7.7 final release
(02-05-2018 09:06 PM)rprosperi Wrote:  Salvo, the PIL-Box has a jumper that sets the baud-rate option 115KB or 230KB. The 230KB is obviously faster, but the 'feeling' is even faster than it sounds and I recommend using 230KB if you can; I am fairly sure it will work at 230KB on OSX, but what s/w are you using?

IL-Per under some Windows subsystem (parallels, etc.) or pyILPer ?

hi Bob,
I'm testing pyILPer now.
Today I set cables and started with PILbox and I saw the jumper set was the #2; should I test put in in #3?

Salvo
∫aL√0mic (IT9CLU) :: HP Prime 50g 41CX 71b 42s 39s 35s 12C 15C - DM42, DM41X - WP34s Prime Soft. Lib
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: pyILPER 1.6.0 and LIFUTILS 1.7.7 final release - salvomic - 02-05-2018 09:40 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication