Post Reply 
(11C) X to Power of X Equation
02-20-2018, 01:49 AM (This post was last modified: 02-20-2018 07:45 AM by Gamo.)
Post: #8
RE: (11C) X to Power of X Equation
According to the 11C Owner's Handbook to used the Newton's Method program.

The user must define the function f(x) by entering into program memory the keystrokes require to find f(x), assuming x is in the X-register. The main program requires register 0-4.

The equation is X^X-1000=0

Program step:

STO 5
RCL 5
Y^X
EEX
3
-

This steps work on the smaller number size because according to the book state that sometime the loop is too much then must change the loop count lower to successfully converge.

Gamo
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
(11C) X to Power of X Equation - Gamo - 02-15-2018, 12:33 PM
RE: (11C) X to Power of X Equation - Gamo - 02-16-2018, 06:36 AM
RE: (11C) X to Power of X Equation - Gamo - 02-19-2018, 01:00 AM
RE: (11C) X to Power of X Equation - Gamo - 02-20-2018 01:49 AM
RE: (11C) X to Power of X Equation - Gamo - 02-20-2018, 09:28 AM
RE: (11C) X to Power of X Equation - Gamo - 02-21-2018, 04:25 AM



User(s) browsing this thread: 7 Guest(s)