3d-printing a thinner HP41CX back cover

Threaded Mode | Linear Mode

3d-printing a thinner HP41CX back cover

02-26-2018, 04:52 PM

Post: #1

atilla457 Offline

Junior Member

Posts: 15
Joined: Jan 2014

3d-printing a thinner HP41CX back cover

Hi there,

I enjoy my 41cx, but sometimes wish it was a little bit thinner. I think there are a couple of people on the forum who are skilled at 3d printed parts. So is it possible to redesign the back cover and make 41cx a little bit thinner?

thanks,

« Next Oldest | Next Newest »

Messages In This Thread

3d-printing a thinner HP41CX back cover - atilla457 - 02-26-2018 04:52 PM

RE: 3d-printing a thinner HP41CX back cover - rprosperi - 02-26-2018, 05:57 PM

RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018, 07:02 PM

RE: 3d-printing a thinner HP41CX back cover - hth - 02-26-2018, 07:29 PM

RE: 3d-printing a thinner HP41CX back cover - Nate Martin - 02-27-2018, 04:58 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 07:48 AM

RE: 3d-printing a thinner HP41CX back cover - brickviking - 02-27-2018, 07:58 AM

RE: 3d-printing a thinner HP41CX back cover - grsbanks - 02-27-2018, 11:01 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 11:42 AM

RE: 3d-printing a thinner HP41CX back cover - Paul Dale - 02-27-2018, 08:04 AM

RE: 3d-printing a thinner HP41CX back cover - toml_12953 - 02-27-2018, 01:19 PM

User(s) browsing this thread: 6 Guest(s)