3d-printing a thinner HP41CX back cover
|
02-26-2018, 05:57 PM
Post: #2
|
|||
|
|||
RE: 3d-printing a thinner HP41CX back cover
(02-26-2018 04:52 PM)atilla457 Wrote: Hi there, While feasible to make the lower portion a small amount thinner (perhaps 1-2mm as it sits just above the CPU board), the thickness of the upper portion cannot be reduced because of the ports for the 4 x ROM/RAM modules. And since that cannot be reduced, very little would be gained by reducing just the lower section. So a lot of work for very little benefit IMHO. --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
3d-printing a thinner HP41CX back cover - atilla457 - 02-26-2018, 04:52 PM
RE: 3d-printing a thinner HP41CX back cover - rprosperi - 02-26-2018 05:57 PM
RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018, 07:02 PM
RE: 3d-printing a thinner HP41CX back cover - hth - 02-26-2018, 07:29 PM
RE: 3d-printing a thinner HP41CX back cover - Nate Martin - 02-27-2018, 04:58 AM
RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 07:48 AM
RE: 3d-printing a thinner HP41CX back cover - brickviking - 02-27-2018, 07:58 AM
RE: 3d-printing a thinner HP41CX back cover - grsbanks - 02-27-2018, 11:01 AM
RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 11:42 AM
RE: 3d-printing a thinner HP41CX back cover - Paul Dale - 02-27-2018, 08:04 AM
RE: 3d-printing a thinner HP41CX back cover - toml_12953 - 02-27-2018, 01:19 PM
|
User(s) browsing this thread: 1 Guest(s)