Post Reply 
3d-printing a thinner HP41CX back cover
02-26-2018, 07:02 PM
Post: #3
RE: 3d-printing a thinner HP41CX back cover
(02-26-2018 05:57 PM)rprosperi Wrote:  the thickness of the upper portion cannot be reduced because of the ports for the 4 x ROM/RAM modules.

Unless you make it a real half-nut with 2 module ports Wink
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018 07:02 PM



User(s) browsing this thread: 4 Guest(s)