The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 795 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 795 errorHandler->error




HP Forums / HP Calculators (and very old HP Computers) / General Forum v / HP-35S Branching Tricks???

Post Reply 
HP-35S Branching Tricks???
04-23-2014, 06:17 AM (This post was last modified: 04-23-2014 06:20 AM by Matt Agajanian.)
Post: #1
Matt Agajanian Offline
Senior Member
 		Posts: 1,117
Joined: Dec 2013
HP-35S Branching Tricks???
Hi there. I finally entered into my 35S the full-featuted polar-rectangular/complex number conversion program from this thread:P/R--Complex Number Conversions

As it contains branches to line numbers, as I added lines, the branching line numbers constantly changed as I was writing the program. So, I decided to just remove the branch instructions and add them after I finished entering the program. Thus, after I finished the program entry, I decided to enter the branch instructions last. As I did so, these branching instruction numbers changed as well but not to the correct locations as this program was written.

Is there a better method to entering the branching instructions as the locations dynamically change?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-35S Branching Tricks??? - Matt Agajanian - 04-23-2014 06:17 AM
RE: HP-35S Branching Tricks??? - r. pienne - 04-23-2014, 08:56 AM
RE: HP-35S Branching Tricks??? - Paul Dale - 04-23-2014, 09:32 AM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication