Post Reply 
HP 9872T Trouble Shooting
06-10-2018, 01:31 PM
Post: #5
RE: HP 9872T Trouble Shooting
Thanks for your reply.

(06-09-2018 11:48 PM)cruff Wrote:  … verify lack of cable damage, that there are no obviously bad capacitors. If you have the service manual, verify all supply voltages are correct.

I looked for cable damage, looked for leaking or swelling capacitors, checked every fuse and verified every supply voltage. Everything seems to be ok, no mice ;-)

BTW: The noise comes from the y-axis motor: if I turn off the y-axis motor (switch “S2 Y MUTE”) the noise vanishes. Unfortunately the plotter shows the same behaviour as before: front panel LEDs “ENTER”, “OUT OF LIMIT”, “ERROR”, and “CHART LOAD” are on and no self test can be started.

Wolfgang
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP 9872T Trouble Shooting - husmann - 06-09-2018, 07:19 PM
RE: HP 9872T Trouble Shooting - husmann - 06-09-2018, 09:56 PM
RE: HP 9872T Trouble Shooting - cruff - 06-09-2018, 11:48 PM
RE: HP 9872T Trouble Shooting - husmann - 06-10-2018 01:31 PM
RE: HP 9872T Trouble Shooting - rprosperi - 06-10-2018, 02:11 PM
RE: HP 9872T Trouble Shooting - cruff - 06-10-2018, 04:29 PM
RE: HP 9872T Trouble Shooting - husmann - 06-10-2018, 08:05 PM
RE: HP 9872T Trouble Shooting - cruff - 06-10-2018, 09:37 PM
RE: HP 9872T Trouble Shooting - husmann - 06-10-2018, 10:49 PM
RE: HP 9872T Trouble Shooting - husmann - 06-13-2018, 11:38 PM
RE: HP 9872T Trouble Shooting - husmann - 06-14-2018, 09:41 PM
RE: HP 9872T Trouble Shooting - husmann - 06-10-2018, 06:47 PM
RE: HP 9872T Trouble Shooting - husmann - 06-16-2018, 10:10 PM
RE: HP 9872T Trouble Shooting - cruff - 03-01-2023, 01:28 PM



User(s) browsing this thread: 2 Guest(s)