41CL How to install CLUTILS-4H

[Podalirius]

(06-21-2018 08:12 PM)cgh Wrote:  

(06-15-2018 01:18 PM)Podalirius Wrote:  Thank you very much for your help!
I have same experiences with the HP-41X emulator by HRAST PROGRAMMER for the hp 50g, that has not every HP-IL support. I ordered a 41CL to use with PIL-BOX to emulate HP-IL peripherals.
I do not know the 41CL so I study et experiences it on my nsimII emulator.
I uograde all .MOD modules from 41CL web site, but honestly I do not know what is the version of 41CL
emulated by my nsimII, if is V2, V3, V4 or V5.
I think is better for me to wait that 41CL board is available again, because even after your help,
no things are changed! The XPMM commads are still NONEXISTENT.
For info, my new page structure is:
Page Port Description
4 = LIBRARY#4 (I do not know how to see the revision of the library)
8 1L OSX3
9 1U YFNX 2B
A 2L PWRX \ Paired in port 2
B 2U XPMM / with XPMM
C 3L MASS
D 3U WRAM

Again thank you very much for your help (and for you very valuable software for 41CL)

Hello,
nsimII emulates the NEWT functions, the flash scheme and programming, the RAM and the MMU (but not the TURBO). It does not take into account the different versions. Normally, You see the maximum flash size. I wrote the emulation when the V3 was deployed. So we can consider that nsimII is at least a V3. I do not follow the new versions but, if there is no change in the NEWT CPU instructions, the emulation should work.

What do you expect to install ? Can you, please, describe me the way you try to do this.
What is the version of nsimII you use ?

I am not very active this time, but if you encounter some trouble when using nsimII, please, do not hesite to contact me be mail. You can send an email to me from this site. I will answer faster

Hi, Thank you very much for your messsage!!!
I use nsimII 0.40.0 installed on Linux Elive 2.9.96 (A Debian based 32bit distro).
After compiling nsimII and dependencies I started the emulator and writed the emulator rom
file to change in a 41CL, then the calculator display of the emulator shows the "MEMORY LOST" message. I immediately pressed XEQ "MMUCLR" then I beginned to insert the desired modules:
with ALPHA 804040-8120 ALPHA XEQ YPOKE I inserted tha Library#4 in Page 4, and so on as
in my previous messages. At the end I pressed XEQ "MMUEN" then I switch off the calculator (click over the ON) and again switch the calculator ON. I pressed the XEQ "STOCFG 1" command.
In any way I am not successful in installing properly the XPMM (CLXPMEM) module, in fact with
commands like YAST or YSTO the calculator/emulator give me the NOEXISTENT massage.
Again, Thank you for your help!