Post Reply 
I made my WP-34S (30b) usable!
01-26-2018, 07:19 AM
Post: #6
RE: I made my WP-34S (30b) usable!
(01-25-2018 09:17 PM)Dave Britten Wrote:  I didn't think to snap any pictures of the insides, mostly because it was so straight-forward. Remove the five screws on the back of the case (two are under the bottom rubber strip), use a small screwdriver to carefully pry the clips in the seam between the front and rear case halves, then deal with lifting the board out of the front case. You might need to work it off some heat stakes, but it's not as bad as doing a Pioneer or a 48. Just be careful of the flex cable holding the LCD to the board, since it's all one piece.

Thanks for sharing.
How did you fix the pca back in place after having the heat stakes undone?

Jose Mesquita member

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: I made my WP-34S (30b) usable! - jebem - 01-26-2018 07:19 AM
RE: I made my WP-34S (30b) usable! - cjmcc - 01-26-2018, 01:44 PM
RE: I made my WP-34S (30b) usable! - jebem - 01-26-2018, 04:08 PM

User(s) browsing this thread: 1 Guest(s)