HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / HP 82324 Measurement Coprocessor Board - Help needed

Post Reply 
HP 82324 Measurement Coprocessor Board - Help needed
02-22-2018, 09:28 PM (This post was last modified: 02-22-2018 10:15 PM by Dave Frederickson.)
Post: #9
Dave Frederickson Offline
Senior Member
 		Posts: 2,186
Joined: Dec 2013
RE: HP 82324 Measurement Coprocessor Board - Help needed
(02-22-2018 06:22 PM)Michael Fehlhammer Wrote:  @ Dave:
Thank you for the link!
But I'm afraid these male connectors don't have the right shape; there has to be an angle of 90 degrees between the retaining screws and the edge connector itself. The edge connector has to lie in the plane of the board, not upright.

Consequently I pointed to a connector series with right-angle mounting options.

https://www.in2connect.uk.com/wp-content...enters.pdf

Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP 82324 Measurement Coprocessor Board - Help needed - Dave Frederickson - 02-22-2018 09:28 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication