Post Reply 
3d-printing a thinner HP41CX back cover
02-26-2018, 05:57 PM
Post: #2
RE: 3d-printing a thinner HP41CX back cover
(02-26-2018 04:52 PM)atilla457 Wrote:  Hi there,

I enjoy my 41cx, but sometimes wish it was a little bit thinner. I think there are a couple of people on the forum who are skilled at 3d printed parts. So is it possible to redesign the back cover and make 41cx a little bit thinner?

While feasible to make the lower portion a small amount thinner (perhaps 1-2mm as it sits just above the CPU board), the thickness of the upper portion cannot be reduced because of the ports for the 4 x ROM/RAM modules. And since that cannot be reduced, very little would be gained by reducing just the lower section. So a lot of work for very little benefit IMHO.

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: 3d-printing a thinner HP41CX back cover - rprosperi - 02-26-2018 05:57 PM

User(s) browsing this thread: 1 Guest(s)