HP Forums / HP Calculators (and very old HP Computers) / General Forum v / 3d-printing a thinner HP41CX back cover

Post Reply 
3d-printing a thinner HP41CX back cover
02-26-2018, 07:02 PM
Post: #3
Didier Lachieze Offline
Senior Member
 		Posts: 1,623
Joined: Dec 2013
RE: 3d-printing a thinner HP41CX back cover
(02-26-2018 05:57 PM)rprosperi Wrote:  the thickness of the upper portion cannot be reduced because of the ports for the 4 x ROM/RAM modules.

Unless you make it a real half-nut with 2 module ports Wink
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018 07:02 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication