Post Reply 
Found these inside a non-working 71B
03-18-2018, 02:30 AM
Post: #138
RE: Found these inside a non-working 71B
(03-18-2018 02:08 AM)Dave Frederickson Wrote:  
(03-18-2018 01:03 AM)MikeSD Wrote:  Does this mod alone allow two 32k to be configures as a single 64K?

This is all that was required to mod an HHP module.

Quote:The programmer has a switch action to do that. I assume this is a photo of your programmer. That switch must factor into operation, which makes me think something else is required. Like adding or removing a ground to do either.

There is the cut trace, which we can presume was connected to VCC in order to set the LCIM bit in the module's config buffer entry. The switch drives the signal to either 6.5 or 0V, probably through some additional circuitry.

Dave

Just past the top right of Dave's picture there are two square pads that I am guessing where originally intended for a surface mount capacitor. The left most one is ground and a convenient place to connect to if you do not intend to include a switch. I did that mod on a pair of modules built into my 71B.

Paul.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
What's U10? - Dave Frederickson - 03-15-2018, 03:43 PM
RE: Found these inside a non-working 71B - Paul Berger (Canada) - 03-18-2018 02:30 AM



User(s) browsing this thread: 36 Guest(s)