Post Reply 
Weird Command in a Program
03-16-2018, 06:42 PM
Post: #6
RE: Weird Command in a Program
The ≠ symbol is Shift H.

On the HP-41C and CV, there is a cheat sheet of the ALPHA key assignments, including all the shifted ones, on the back of the calculator. The 41CX expects you to know all that, and shows ED mode key assignments instead.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Weird Command in a Program - Neve - 03-16-2018, 06:05 PM
RE: Weird Command in a Program - SlideRule - 03-16-2018, 06:13 PM
RE: Weird Command in a Program - Neve - 03-16-2018, 06:37 PM
RE: Weird Command in a Program - Dieter - 03-16-2018, 06:51 PM
RE: Weird Command in a Program - Dieter - 03-16-2018, 06:16 PM
RE: Weird Command in a Program - Neve - 03-16-2018, 06:35 PM
RE: Weird Command in a Program - Thomas Okken - 03-16-2018 06:42 PM
RE: Weird Command in a Program - Neve - 03-16-2018, 06:59 PM
RE: Weird Command in a Program - Neve - 03-16-2018, 07:22 PM
RE: Weird Command in a Program - Gene - 03-16-2018, 07:40 PM
RE: Weird Command in a Program - hth - 03-16-2018, 07:41 PM
RE: Weird Command in a Program - Neve - 03-16-2018, 08:42 PM
RE: Weird Command in a Program - Neve - 03-17-2018, 12:16 AM



User(s) browsing this thread: 1 Guest(s)