Post Reply 
Pushing the 15C to its limits (software labels?)
04-08-2018, 11:37 PM
Post: #1
Pushing the 15C to its limits (software labels?)
Hey everyone.

When I exceeded the 5 User programs limit I wrote a tool for quick remapping, but now I'm running into the 20 programs limit because there are only 20 labels.

Now, it's possible to jump to line numbers using the I register, but since programs can move around those line numbers should probably not be hardcoded on the call site. I think what's needed is a software GTO command that uses some lookup table, either in registers or in program memory. I have some ideas but... has all of this happened before?

I mean, those calculators are from the 80s. Surely ,every limit I bump into must have been overcome before I was born... What's the well-engineered way to deal with label shortage or to get the most out of that calculator in general?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Pushing the 15C to its limits (software labels?) - Michael Zinn - 04-08-2018 11:37 PM



User(s) browsing this thread: 1 Guest(s)