Post Reply 
Help With Using the Math Module
04-23-2018, 01:29 AM
Post: #3
RE: Help With Using the Math Module
(04-23-2018 01:19 AM)Gene Wrote:  Change the status of flag 21. If it is set, then CF 21 or vice versa. That should cause the 41 to stop when displaying output like that.

Gene,

Thanks for the quick reply. I just now tried what you suggested.

First I checked the status of flag 21 and it was set.
I then cleared it.
I actually tested it again to be sure it was not set.
I then ran the SINZ function (as described above).
Unfortunately, no change.

I discovered that executing the function SINZ caused flag 21 to be set.

I checked my manual and flag 21 is the printer enable flag. I could not find another flag in the manual that seemed to address my needs.

Just a nerd girl with too much alphabet soup behind her name and an HP-41CX.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Help With Using the Math Module - ID_girl - 04-23-2018, 01:16 AM
RE: Help With Using the Math Module - Gene - 04-23-2018, 01:19 AM
RE: Help With Using the Math Module - ID_girl - 04-23-2018 01:29 AM
RE: Help With Using the Math Module - Gene - 04-23-2018, 01:40 AM



User(s) browsing this thread: 1 Guest(s)