WP-34S / 31S Key Caps?

[Jake Schwartz]

Hi,

I just read about that Kickstarter project for a "consumer" 3D printer here and had a thought. Assuming that a 3D printer in the near future becomes reasonably priced and can combine multiple-colored plastics into single objects, I wonder if thin 3D-printed key caps with the '34S or '31S functions could be built, which could then be glued to the 20b or 30b key tops. I am beginning to wear out my adhesive labels with repeated use and at least one label is starting to lift off by itself.

Jake