Post Reply 
HP-35S Branching Tricks???
04-23-2014, 06:17 AM (This post was last modified: 04-23-2014 06:20 AM by Matt Agajanian.)
Post: #1
HP-35S Branching Tricks???
Hi there. I finally entered into my 35S the full-featuted polar-rectangular/complex number conversion program from this thread:P/R--Complex Number Conversions

As it contains branches to line numbers, as I added lines, the branching line numbers constantly changed as I was writing the program. So, I decided to just remove the branch instructions and add them after I finished entering the program. Thus, after I finished the program entry, I decided to enter the branch instructions last. As I did so, these branching instruction numbers changed as well but not to the correct locations as this program was written.

Is there a better method to entering the branching instructions as the locations dynamically change?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-35S Branching Tricks??? - Matt Agajanian - 04-23-2014 06:17 AM
RE: HP-35S Branching Tricks??? - r. pienne - 04-23-2014, 08:56 AM
RE: HP-35S Branching Tricks??? - Paul Dale - 04-23-2014, 09:32 AM



User(s) browsing this thread: 1 Guest(s)