HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Preferred calculator program language

Post Reply 
Preferred calculator program language
12-09-2018, 02:05 PM
Post: #21
Thomas Okken Offline
Senior Member
 		Posts: 1,894
Joined: Feb 2014
RE: Preferred calculator program language
(12-06-2018 09:54 PM)grsbanks Wrote:  
(12-06-2018 09:35 PM)HP67 Wrote:  I don't have a Prime so I haven't seen the language it uses.

HP-PPL. It's similar to Pascal and therefore structured and procedural.

It's also freakin' fast, especially on the latest and greatest G2 (Rev. D hardware).

If I were to shop around for a Prime, how could I make sure I got one with the latest and greatest hardware? If I were to buy direct from HP, could I end up with an older model?

On an unrelated note, I just took a look at the HP web site, and noticed that the 12C and 12cp are out of stock. Is that a coincidence, or are they finally being discontinued?
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Preferred calculator program language - Thomas Okken - 12-09-2018 02:05 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication