HP-41 Byte Table
|
12-28-2018, 11:27 PM
(This post was last modified: 12-28-2018 11:28 PM by JurgenRo.)
Post: #14
|
|||
|
|||
RE: HP-41 Byte Table
(12-28-2018 11:25 PM)JurgenRo Wrote: [quote='Sylvain Cote' pid='109582' dateline='1546031875'] Hi Sylvain, thanks for clarification. I'm aware of the "automatic decompilation/compilation" as necessity to get jump-instructions right after, say, modifying an existing program which contains GTOs or XEQs. I was just referencing to hth's remark " ... do not worry about which nibble you use unless you have an early machine (bug 8 I think) ...". I'm using a CX, so I do not worry Anyway, I'm not aware what old machine's "bug 8" actually is doing. But because I have an older 41C as well, I'd clearly be curious to know what this bug does. So, any information about this bug (or, for that matters, any bug of the 41) would be highly appreciated! Thanks again, Sylvain! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP-41 Byte Table - JurgenRo - 12-27-2018, 07:54 PM
RE: HP-41 Byte Table - Thomas Okken - 12-27-2018, 08:31 PM
RE: HP-41 Byte Table - JurgenRo - 12-27-2018, 09:05 PM
RE: HP-41 Byte Table - JurgenRo - 12-27-2018, 09:11 PM
RE: HP-41 Byte Table - Sylvain Cote - 12-28-2018, 04:43 PM
RE: HP-41 Byte Table - JurgenRo - 12-28-2018, 08:34 PM
RE: HP-41 Byte Table - Sylvain Cote - 12-27-2018, 09:02 PM
RE: HP-41 Byte Table - JurgenRo - 12-27-2018, 10:46 PM
RE: HP-41 Byte Table - Thomas Okken - 12-27-2018, 09:18 PM
RE: HP-41 Byte Table - JurgenRo - 12-27-2018, 09:22 PM
RE: HP-41 Byte Table - hth - 12-28-2018, 05:14 PM
RE: HP-41 Byte Table - JurgenRo - 12-28-2018, 08:44 PM
RE: HP-41 Byte Table - Sylvain Cote - 12-28-2018, 09:17 PM
RE: HP-41 Byte Table - Thomas Okken - 12-28-2018, 11:44 PM
RE: HP-41 Byte Table - JurgenRo - 12-28-2018, 11:57 PM
|
User(s) browsing this thread: 2 Guest(s)