HP Classic Calculator (HP-65) back label

[albertofenini]

Eventually we had a chance to open and repair an HP-45 of our collection.
We used the occasion to test the glue, we removed the label, we tried to get it as flat as possible,
and we sprayed the back with the 3M glue.
Than we put some paper clips and some cork sheets to get homogeneous pressure on the label
and this is the result.
It is not bad being our first try but it is far from the original look.
There are noticeable wrinkles and we believe the in order to have a very good result the label must
be perfectly flat (our was not ...)
Any comment or advice is always welcome ...