HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Adapting cell battery to HP 41

Post Reply 
Adapting cell battery to HP 41
08-04-2020, 10:56 AM (This post was last modified: 08-04-2020 10:56 AM by Hans-Peter.)
Post: #32
Hans-Peter Offline
Member
 		Posts: 101
Joined: Dec 2013
RE: Adapting cell battery to HP 41
Quote:Turns out that LiFePO4 cylindrical cells (3.2 volts each)

Be careful with two LiFePo cells. These have 3.6V per cell at full charge. That would be 7.2V and probably too high to survive.
I have connected two LiFePo4 cells of Soshine AAA size in parallel and added a 5V step-up converter. These have only 2x280mAh but they are suitable for lower temperatures outside.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Adapting cell battery to HP 41 - cruff - 02-26-2019, 12:45 PM
RE: Adapting cell battery to HP 41 - Hans-Peter - 08-04-2020 10:56 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication