TI-95 Procalc
|
06-13-2019, 01:36 PM
(This post was last modified: 06-13-2019 01:39 PM by toml_12953.)
Post: #11
|
|||
|
|||
RE: TI-95 Procalc
(06-13-2019 07:16 AM)grsbanks Wrote:(06-12-2019 05:29 PM)toml_12953 Wrote: The Centronics printer port is also known as the parallel port. You could look it up! My bad! I read it as, "There is no such thing AS parallel ports" instead of "There is no such thing FOR parallel ports" That makes all the difference in the world! I, too, have been using computers a while ever since I built a logic trainer out of an Intel 4004. I also bought the parts for a Mark-8 (Intel 8008) but I never did get to build it. Before I could, some guy in Albuquerque, NM came out with a practically empty box built around an Intel 8080A that cost less than the CPU chip alone! I just HAD to get that Altair 8800. Tom L Cui bono? |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
TI-95 Procalc - Leviset - 06-11-2019, 04:01 PM
RE: TI-95 Procalc - Massimo Gnerucci - 06-11-2019, 08:15 PM
RE: TI-95 Procalc - toml_12953 - 06-12-2019, 12:12 AM
RE: TI-95 Procalc - Leviset - 06-12-2019, 11:26 AM
RE: TI-95 Procalc - Leviset - 06-12-2019, 02:41 PM
RE: TI-95 Procalc - grsbanks - 06-12-2019, 03:19 PM
RE: TI-95 Procalc - Sylvain Cote - 06-12-2019, 03:57 PM
RE: TI-95 Procalc - toml_12953 - 06-12-2019, 05:29 PM
RE: TI-95 Procalc - grsbanks - 06-13-2019, 07:16 AM
RE: TI-95 Procalc - toml_12953 - 06-13-2019 01:36 PM
RE: TI-95 Procalc - Leviset - 06-12-2019, 07:46 PM
|
User(s) browsing this thread: 1 Guest(s)