Post Reply 
HP-67 Charger Connector
06-29-2019, 02:37 PM (This post was last modified: 06-29-2019 02:39 PM by twoweims.)
Post: #5
RE: HP-67 Charger Connector
Here is progress so far:
   

This is my first attempt using a LiPo battery and charger. Unfortunately the largest LiPo battery that I have found that will fit in the battery compartment is 1000 mAh. But the setup works very well. The photo also shows my first attempt at recreating the connector. It fits and operates the shorting mechanism properly. I just need to find the sockets so I can finalize the model.

The connector will eventually be built into the charger case so there will be no wires hanging out.

I even found some PLA that almost matches the HP-67 original color. Sample chip is to the right of the calculator.

Still a work in progress but moving in a positive direction.

Thanks for all your suggestions.

-Dan
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-67 Charger Connector - twoweims - 06-27-2019, 02:05 PM
RE: HP-67 Charger Connector - mfleming - 06-28-2019, 05:33 AM
RE: HP-67 Charger Connector - [kby] - 06-28-2019, 06:46 AM
RE: HP-67 Charger Connector - Robert VM - 06-29-2019, 10:31 AM
RE: HP-67 Charger Connector - [kby] - 06-30-2019, 07:06 AM
RE: HP-67 Charger Connector - twoweims - 06-30-2019, 04:27 PM
RE: HP-67 Charger Connector - twoweims - 06-29-2019 02:37 PM
RE: HP-67 Charger Connector - mfleming - 06-30-2019, 02:52 PM
RE: HP-67 Charger Connector - twoweims - 06-30-2019, 04:32 PM



User(s) browsing this thread: 1 Guest(s)