HELP on TI-59 Module
|
10-15-2019, 08:48 AM
Post: #1
|
|||
|
|||
HELP on TI-59 Module
Hi to everyone,
Recently I bought two modules on ebay: Statistics and Real Estate. When I checked the contacts of the two modules I realized that they were oxidized, I tried to scratch them to remove the oxide. When I tried the Real Estate module, when I executed the 2nd PGM 01 operation, a fading C appeared on the left. Same behavior also with the Statistics module. Once I was able to run the diagnostics on the Real Estate module in a positive way by looking at a number 3 on the display (module number). I tried to compare the contacts of the Master Module with the contacts of the RE and ST modules, I noticed that in the latter the contacts are smaller. The Master Module works correctly. Oxidation and smaller contacts could cause the problem of not reading the form? I enclose photo contact forms. I thank you in advance for your suggestions. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HELP on TI-59 Module - Doctor_Jacek - 10-15-2019 08:48 AM
RE: HELP on TI-59 Module - toml_12953 - 10-15-2019, 01:27 PM
RE: HELP on TI-59 Module - Doctor_Jacek - 10-15-2019, 02:26 PM
RE: HELP on TI-59 Module - Xorand - 10-22-2019, 01:21 AM
|
User(s) browsing this thread: 1 Guest(s)