HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Question about displaying strings

Post Reply 
Question about displaying strings
10-20-2019, 02:43 AM
Post: #1
DrDarius Offline
Junior Member
 		Posts: 41
Joined: Oct 2019
Question about displaying strings
This is a question from a HP Prime newbie (I bought HP Prime G2 two weeks ago).

Is there a way to center a string given as a variable displayed on the screen with TEXTOUT (or ..._P) command?
I could not find any command which would return the length of the string in pixels. Hp Prime is using proportional font, so DIM() command is not of much help.

I did not browse though the history of this forum thoroughly, so, in case if this issue has been already addressed in the past, I apologize for bringing it up again.

Darius
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Question about displaying strings - DrDarius - 10-20-2019 02:43 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication