Post Reply 
NP-25 Calculator 3d case and keys design
02-26-2020, 11:48 AM
Post: #6
RE: NP-25 Calculator 3d case and keys design
(02-26-2020 04:28 AM)Craig Bladow Wrote:  
(02-26-2020 04:08 AM)Steve Simpkin Wrote:  I think Massimo was referring to the backslash symbol on the divide key on the lower-left key of the completed case. The original HP-25 had an obelus division symbol on this key.

Oh, thank you for the explanation, the symbol choice is a combination of the readily available font and limited time to find a work around. The proper division symbol did not print clearly with the equipment I am using. All of the key legends could be made clearer by printing on a resin printer or using a smaller nozzle diameter on an fdm printer.

Yes Steve, that was it.

It's strange that "\" prints out better than "/" while I understand that "÷" can be problematic if resolution is coarser.


-+×÷ ↔ left is right and right is wrong
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: NP-25 Calculator 3d case and keys design - Massimo Gnerucci - 02-26-2020 11:48 AM

User(s) browsing this thread: 1 Guest(s)