Post Reply 
NP-25 Calculator 3d case and keys design
02-26-2020, 01:37 PM
Post: #7
RE: NP-25 Calculator 3d case and keys design
(02-26-2020 11:48 AM)Massimo Gnerucci Wrote:  It's strange that "" prints out better than "/" while I understand that "รท" can be problematic if resolution is coarser.

I don't remember if there was a issue with "\" vs "/". I just checked NQ41 and it uses "/" for division.

Try CC41!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: NP-25 Calculator 3d case and keys design - Craig Bladow - 02-26-2020 01:37 PM



User(s) browsing this thread: 1 Guest(s)