Post Reply 
Important - Reupdate your unit!
06-02-2014, 03:02 PM (This post was last modified: 06-02-2014 03:47 PM by aurelio.)
Post: #51
RE: Important - Reupdate your unit!
(06-02-2014 02:21 PM)Tim Wessman Wrote:  
(06-02-2014 12:34 PM)aurelio Wrote:  I got an unexpected result updating my prime.
The updating failed and now even if I reset the calculator the display stops on the equation splash. The calculator does not respond any more...............
Tim, what must I do?

Hold down the SYMB button, press a pin in the back, you will be back in the updater. Retry the update by running the updater.exe directly from the install directory.
Thank-you TIM, I've tryed with two PC's and 9 different USB ports, but unsuccessfully, altough each time the PC recognized the USB devices (PRIME updaters)
The display shows an error message (unknown command), each time with a different code..
Now after the pin and symb reset the display shows not only "HP Prime recovery mode V13" but also "CodeEntry: 0x0"

EDIT:
Just now I can see that the problem was due to a bad USB connection

and the problem was the cable, not the USB nor the PC

Excuse me if I did not read the other posts before
thank-you again
Now the upgrade is done.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Important - Reupdate your unit! - DrD - 05-29-2014, 08:06 PM
RE: Important - Reupdate your unit! - DrD - 05-29-2014, 10:52 PM
RE: Important - Reupdate your unit! - JimS - 05-29-2014, 11:33 PM
RE: Important - Reupdate your unit! - DrD - 05-30-2014, 09:11 AM
RE: Important - Reupdate your unit! - JimS - 05-30-2014, 02:36 PM
RE: Important - Reupdate your unit! - HP67 - 07-01-2014, 07:06 AM
RE: Important - Reupdate your unit! - aurelio - 06-02-2014 03:02 PM



User(s) browsing this thread: 2 Guest(s)