Hp-41C card reader - dead
|
05-20-2022, 07:56 AM
Post: #81
|
|||
|
|||
RE: Hp-41C card reader - dead
I used a multimeter one probe on the vertical knife and the other on the copper strip on the upper PCB. There is continuity so the knives are all connected properly.
When you guys launch the Catalog 2 command do you also get as a first line of the list the entry I get on the photo? Thank you Marco |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 8 Guest(s)