Scrolling with rev 6030
|
06-01-2014, 05:59 PM
Post: #4
|
|||
|
|||
RE: Scrolling with rev 6030
This was also the subject of fablab48's angry complaint a day or two ago. I agree with Helge. With the new firmware, page up/down while editing larger programs became slower and much less usable. At least there is buffering so you can touch the arrow 10 or 15 times and wait about 10 seconds for the editor to catch up and display the appropriate page.
The scrolling was actually slow for larger programs with rev 5447 and I've formed no opinion of whether it's gotten worse or not. The program I'm working on is about 70 calculator pages. I forget how big it got before I noticed the slow scrolling in 5447. I was just about done with it, but it's now on life support due to undocumented changes in the Wait(-1) command. I'm very frustrated by 6330/6331 and discouraged from spending my time programming in an unstable, partially documented environment. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Scrolling with rev 6030 - Helge Gabert - 05-31-2014, 04:57 PM
RE: Scrolling with rev 6030 - Alberto Candel - 05-31-2014, 06:53 PM
RE: Scrolling with rev 6030 - Helge Gabert - 05-31-2014, 07:15 PM
RE: Scrolling with rev 6030 - Jsather - 06-01-2014 05:59 PM
RE: Scrolling and Flicker with rev 6030 - Helge Gabert - 06-05-2014, 05:15 PM
RE: Scrolling with rev 6030 - eried - 06-05-2014, 06:08 PM
RE: Scrolling with rev 6030 - Helge Gabert - 06-05-2014, 07:56 PM
RE: Scrolling with rev 6030 - eried - 06-05-2014, 08:03 PM
RE: Scrolling with rev 6030 - Kevin Ouellet - 06-05-2014, 07:18 PM
|
User(s) browsing this thread: 1 Guest(s)